Easiest method to cut carpet.
How to cut up carpet.
Pull up a few feet of carpet and fold it over.
If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife.
Next place the tip of a utility knife against the carpet backing and press until it pierces the backing.
To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.
The process of removing carpet padding is very similar to pulling up the carpet itself except it s typically much lighter.
When you cut carpet you need to make sure that you cut it straight.
One way to do this is to lift the carpet away from the floor as you cut.
Again these smaller strips will be much easier for you to remove from the room.
Use a utility knife with a sharp new blade to cut through the carpet backing.
Then grab the carpet by hand and continue to pull it up along an entire wall.
Use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go.
Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.
Just grab the carpet with pliers and pull.
One of the most important things that you will want to do is use a straight edge.
Use the harbor freight oscillating multi tool cutting tool to easily cut your carpet.
Use a straight edge.
Fold back about 3 ft.
Carpet knives are similar in theory to regular utility knives but they are specifically designed to cut carpet.
Instead of raking your blade across the carpet and through the padding to make a cut just make a 4 5 inch hole and use your fingers to pull the carpet up with one hand then cut the raised carpet.
They are ideal for areas where you need to cut around things such as heating vents doorways or cabinets or for trimming up edges such as around walls where you may have cut a little long with your initial measurements.
You may have wavy walls bay or bow windows that create awkward floor space or built.
Every few feet use your utility knife to cut the padding into strips.
Start at one wall and roll the carpet padding away from your subfloor.
Keep both hands on the knife to avoid cutting a free hand.
A long metal straight edge is.
Of carpet and cut it into easy to handle strips photo 1.
To cut carpet for installation start by unrolling the carpet so that the backside is facing up.
A room is rarely ever just a box with perfectly straight walls.
Roll or fold the strip secure with duct tape and remove it from the room.
A straight edge is going to be necessary to guide your knife along the edge of the carpet.
