Honeywell Water Heater Gas Valve Pilot Won T Stay Lit

Sometimes this tubing will get kinked in places which will prevent proper operation.

Honeywell water heater gas valve pilot won t stay lit.

A bad thermocouple will shut off gas to both the pilot and the. The gas supply to the pilot assembly is controlled by this valve. If your hot water heater suddenly stops working chances are a bad thermocouple has shut off the gas to the pilot light. When you depress the button it bypasses the thermopile.

Another possible reason why a pilot won t stay lit has to do with the flex tubing. The chimney has been cleaned and the door to the furnace room read more. Here s a solution for your hot water tanks that won t stay lit. Replacement is an easy diy repair.

If you don t see a spark at all when you are trying to light your pilot it may be that you are not looking in at the right angle. A thermocouple senses the heat of the pilot and allows gas to flow to the burner. The air intake is located on the bottom or side of the water heater and may need to be cleaned out in order for the pilot to stay lit. This tubing connects to the gas controller and will ensure a steady stream of gas.

The gas valve is out which makes the pilot light keep going out and now wont stay on. This is also a likely cause if the pilot won t ignite at all. Replacement of this part should be. If your gas water heater doesn t stay lit you may have a defective control thermostat.

Replacement of this part should be. There are other tanks that have light sensors flame sensors and someone if that s yours th. Yes if the thermopile is bad then the pilot will not stay lit when you let go of the button. You have to put your ear down to the floor to see the pilot.

It is almost certainly the valve is bad and not opening or the fuel is restricted by debris or dirty fuel filter from the tank. As a result the pilot doesn t get enough fuel to stay lit. If your gas water heater doesn t stay lit you may have a defective control thermostat. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature.

Thankfully a dirty pilot tube is the easiest issue to fix. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature. If this is the problem then unkinking the tube will occasionally resolve the issue. Dirt and debris can collect in the pilot tube causing the flow of gas to be blocked.